LDA Overhead Bridge Crane is widely used in plants warehouses, material stocks to lift goods. It is prohibited to use the equipment in the combustible, explosive or corrosives environment.
LDA Overhead Bridge Crane has two operational methods, ground or operational room which has open model and closed model and can be installed on left or right side according to the practical situation. And the direction of entering the gate has two forms, sideway and ends in order to satisfy the users' Choice users' different conditions.
Main Feature of LDA Overhead Bridge Crane
1). Compact design, optimal use of the work areas
2). Heavier loads, wider spans and higher working frequency
3). Control the load easily, position the load exactly
4). "One-Stop Shop" for your crane and hoist needs
5). Superior safety and reliability
Consist of Overhead Bridge Crane
1. Main beam- The main traveling structure of the crane which
spans the width of the bay and travels in a direction parallel to the runway.
The bridge consists of two end trucks and one or two bridge girders depending
on the equipment type. The bridge also supports the trolley and hoisting
mechanism for up and down lifting of load.
2. End trucks- Located on either side of the bridge, the end
trucks house the wheels on which the entire crane travels. It is an assembly
consisting of structural members, wheels, bearings, axles, etc., which supports
the bridge girder(s) or the trolley cross member(s).
3. Bridge Girder(s)- The principal horizontal beam of the crane
bridge which supports the trolley and is supported by the end trucks.
4. Runway - The rails, beams, brackets and framework on which the crane
operates.
5. Runway Rail- The rail supported by the runway beams on which
the crane travels.
6. Hoist- The hoist mechanism is a unit consisting of a
motor drive, coupling, brakes, gearing, drum, ropes, and load block designed to
raise, hold and lower the maximum rated load. Hoist mechanism is mounted to the
trolley.
7. Trolley -The unit carrying the hoisting mechanism which
travels on the bridge rails in a direction at right angles to the crane runway.
Trolley frame is the basic structure of the trolley on which are mounted the hoisting
and traversing mechanisms.
8. Bumper (Buffer)- An energy absorbing device for reducing impact
when a moving crane or trolley reaches the end of its permitted travel, or when
two moving cranes or trolleys come into contact. This device may be attached to
the bridge, trolley or runway stop.
Contact: Bruse Skype:nucleoncranegroup
Phone: WhatsAPP:008618637120986
Tel: 0086 371 65657585
Email: info@nucleoncranegroup.com
Add: Crane Industrial Park, Changyuan County, Henan Province, China