Introduction of Metallurgical Wire Rope Hoist Design

Introduction of Metallurgical Wire Rope Hoist Design

Metallurgical Wire Rope Hoist Design: working environment temperature should under 60 ℃, the working level is M5, M6 ,Altitude below 1000m, the use of the site shall not have flammable and explosive and corrosive gases. The power supply for the three-phase AC, 50HZ, 380V. Electric hoist hoisting mechanism working level M6, with support (work) brakes and safety brakes. In normal operation, the drive mechanism is braked by a support brake provided on a tapered rotor motor. If any of the transmission systems between the motor and the reel fails, causing the hanger and the load to descend at an over speed rate, the brake is stopped by a safety brake provided on the reel to prevent the oversize from falling accident.

    Wire Rope Hoist Design not only set the double brake and set a double lift limit and drop limit device, while setting the over current protection, loss of voltage protection, phase sequence protection, from the weight overload limiter, down speed power protection Safety protection device. Enhance the safe use of electric hoist performance. The insulation grade of the motor is H-grade, and the steel wire 6 × 371WR wire rope meets the requirements of metallurgical production conditions.

        When the reducer and the motor below the high temperature insulation protection function, in the electric hoist under the shell design and installation of the whole insulation board to isolate the high heat of molten metal radiation.

        Wire rope two-speed metallurgical Wire Rope Hoist Design control type using remote control or non-follow-type away from the heat source control to ensure the safety of the operator's body.