How to clean electric overhead travelling cranes

How to clean electric overhead travelling cranes

Nucleon is a electric overhead travelling cranes, electric travelling gantry crane, coal series hoisting equipment, small light lifting equipment and other products of research and development, manufacture, installation, sales and service as one of the Sino-foreign joint ventures. We provide high quality products and after-sales service! Welcome to consultation!

The equipment has been widely used in port, construction, corrosion protection, petroleum, chemical, steel, metallurgy, mining and so on.

No matter whether you work outdoors or indoors, you can't avoid the heavy dust in the environment. The dust accumulated on the crane after a long night, when dust meets oil, steam, or water vapor areas, it forms sludge and attaches to the surface of the crane components. Oil sludge not only affects the cleaning of crane parts, may also bring the risk of spontaneous combustion, and to speed up the aging of the crane parts, damage rate, and therefore should promptly remove these sludge.

At present, there are two special cleaning agents, such as mist and foam, to clear the sludge. First remove the dust and other debris with a brush, then detergent evenly spray where there is oil sludge. When spraying, but also pay attention to avoid electric wire, electrical and other sensitive areas. When these sensitive areas also need to remove sludge and can use the cloth with detergent to wipe. Sprayed with detergent, in order to allow the cleaning agent completely decomposed oil sludge, it is best to wait five minutes later, and then brush to scrub. Brushes off at this time of sludge is very simple to solve, it with clear water is rinsed clean. Finally, after all the parts are dried, Sprayed with nursing agent. For crane after removal of oil sludge, because this part is basic to cool down. In order to avoid the influence of detergent on the surface of parts, it is better to stop using them.